Avanti FF999PS Manuel d'utilisateur Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
OPERATING YOUR APPLIANCE
> Temperature Control Panels
Refrigerator Temperature Control Freezer Temperature Control
MAX
TEMP CONTROL
-W—
I I I I I I
6 5 4 3 2 1
MIN
> Setting the Temperature Control
Your refrigerator has a separate control for regulating the temperature for each section independently.
The temperature control is located at the rear of each section (refrigerator / freezer). (See the graphics
shown above).
The first time you turn the unit on, set the temperature control to “MAX” in refrigerator section and
“MAX” in freezer section.
The range of the temperature controls are from position “OFF” to “MAX” the coldest in refrigerator
section and from position “MIN” the warmest to “MAX” the coldest in the freezer section. After 24 to
48 hours, adjust the temperature control to the setting that best suits your needs. The setting of “3”
in refrigerator section and the mid range between “MIN” and “MAX” in freezer section should be
correct for home or office refrigerator use.
NOTE:
IF THE UNIT IS UNPLUGGED, HAS LOST POWER, OR IS TURNED OFF, YOU MUST WAIT 3
TO 5 MINUTES BEFORE RESTARTING THE UNIT. IF YOU ATTEMPT TO RESTART BEFORE
THIS TIME DELAY, THE REFRIGERATOR-FREEZER WILL NOT START.
TURNING THE REFRIGERATOR TEMPERATURE CONTROL TO “OFF” POSITION STOPS THE
COOLING CYCLE BUT DOES NOT SHUT OFF THE POWER TO THE UNIT.
> Using Your Ice Cube Tray
Recommended thermostat setting for ice making is position “MAX”.
Fill the ice cube tray (two thirds of it) with cold water or with any liquid suitable for
freezing and place the tray on the bottom of the freezer to freeze properly.
Dry the tray, otherwise it may stick to the bottom of the freezer.
The best method to get ice cubes out of the tray is to hold the tray under cold tap
water for a second.
To eject the ice cubes from the tray, place over the ice bucket and twist slightly
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire